Learn how to apply press on lashes underneath your natural lashes for a seamless, defined finish at home. With pre applied adhesive, Milarēs press on lash clusters simplify the under lash application technique — no separate bond or glue needed.
Applying each cluster beneath your natural lashes helps keep the band discreet while giving you control over your lash look. Choose your preferred style and length, then build soft everyday definition, a wispy finish or fuller volume one cluster at a time.
Follow our step by step press on lash application guide below to learn how to prep your natural lashes, position each cluster and gently clamp to secure. Watch each step for a closer look at the placement technique, then follow each step at your own pace.
Ensure your natural lashes are clean, dry, and free from oils or makeup. This helps the pre applied adhesive grip securely and wear smoothly.
For best results, curl your natural lashes before application to help the lash clusters blend seamlessly and sit flush beneath the lash line.
Carefully remove the lash cluster using our non stick applicator, close to the base but avoiding direct contact with the band, as this is where the adhesive is (it's very sticky).
Starting from the outer corner, apply each cluster just above your lash line in an upward motion — you will feel it grab onto your natural lashes.
When applied correctly, you should not feel the clusters at all. Avoid making contact with your waterline — the lash clusters should sit directly above it. If you feel the clusters, use the applicator to gently pull the lash cluster a little higher.
It helps to pull your eyelid up slightly so that you can easily see where to place each cluster.
Using your lash applicator, gently clamp your lashes to secure, removing slowly and on a slight angle to avoid your lash clusters from coming off.
For an even more secure hold, gently clamp your lashes at the base using a lash curler.
THE KEY TO LONG LASTING RETENTION
GOOD TO KNOW
- Avoid oil based products around the eyes and keep the lashes dry for the first 24 hours after application
- Cleanse lashes gently using a cotton tip and water based cleanser to avoid build up from day to day oil build up
Yes — the lashes are waterproof. However please avoid water or steam for the first 24 hours after application and excessive exposure to oils to allow the bond/adhesive to fully set.
- Apply to clean lashes free from any skincare, makeup or oils
- Use your lash curler with a light coat of seal, to clamp your lash clusters after application for a more secure hold
- Allow the adhesive to fully set and avoid water or steam for the first 24 hours
- Avoid rubbing your eyes, and handle the lashes gently to maintain their hold
Gently peel the press on lashes away, working slowly from the outer corner inwards. No remover is needed — take your time and avoid tugging on your natural lashes.
Before applying a new set, ensure your natural lashes are clean, dry and free from oils, makeup and skincare.
NEED HELP?
REFINING YOUR TECHNIQUE
If you’re new to using press on lashes or the under lash application technique, allow a few attempts to find your rhythm. Once familiar, the process becomes quick, seamless, and second nature.
If you need guidance at any stage, feel free to reach out — our team is always here to help.